This one was definitely long overdue. This video is actually the spawn of my most successful video How to make DIY polyurethane engine mounts. A lot of people asked these two things in the comments. Continue reading Polyurethane vs. Stock Engine Mounts – A detailed comparison
You know what’s really hard? When you think you have finally reached your goal but it turns out to be the beginning of just another struggle. Continue reading Troubleshooting my 4age engine
I decided that aftermarket polyurethane engine mounts are too expensive, so I went the DIY route and made my own. Watch the video, all the info is there:
My coolant overflow tank was sitting in my car for far too long and it was simply horrible. With a ton of 30 year old sludge, dirt, discoloration and anything else you can imagine. Good quality replacement coolant tanks for my car (1987 MR2 mk1 AW11) don’t exist, and used ones are usually in similar condition. Continue reading How to make your coolant overflow tank white again
Did this too. I went a bit overboard with the injector cleaning. I had them profesiionally cleaned in an ultra-sonic bath and then I had them rebuilt using a rebuild / service kit. I got the kit for $ 17.
Here’s a little video that shows you how to rebuild your clutch slave cylinder. Pretty straightforward. Continue reading How to rebuild a clutch slave cylinder
All I can say is “Holy f**k porting and polishing a cylinder head takes forever! Imagine a number of hours you think its going to take. Now whatever you imagined, double, or heck, even triple it. I ported and polished a 4 cylinder head from my 4age 16v bigport engine from my 1987 Toyota MR2 mk1 (aw11) and it took me 40+ hours, probably more since I lost count somewhere along the way. Continue reading Cylinder head porting and polishing – how to diy guide video
Now when I think back and remember that I was considering to rebuild my manual transmission myself I get really happy that I made the right decision and took it to a professional. Watch the video for the full assembly of the transmission. Continue reading Manual transmission full assembly video
Did this too. Was really scared of doing the wiring harness at first, because I have zero experience with wires or anything electrical, but after reading a bunch of articles and watching a few videos I realized it wasn’t all that scary.
Continue reading How to DIY – wire harness restoration
Here’s a pretty useful video if you ever wanna tackle a transmission rebuild yourself. This time I’m just filming and watching a pro do it. Keeping my hands clean for once 🙂 Continue reading How to disassemble a manual transmission? C50